|
Ni-Cd/Ni-MH Battery Charger with Delta-V (8 type Cable) |SC-U2
SC-U2 (v2.0)
Quick charge Model: SC-U2 (V2.0-03-2010)
This charger is an intelligent charger especially designed to charge rechargeable 2/4pcs AA or 2pcs AAA Ni-MH rechargeable batteries
Specifications: - Input: AC 100-240VAC, 50/60Hz - Output: 2.8V AA 2X500mA, 4X500mA,
AAA 2X500mA

Main Features: Charge:2/4pcs AA or 2pcs AAA Ni-MH batteries
MCU control
- Bad battery, Alkaline and primary battery detection
- Short-circuit protection - Over voltage cut-off protection - Charge Method : negative Delta V or zero Delta V cut off
- Time control ------------- after charge 6 hour, the power cut down - Temperature control ---- temperature >55 degree, the power cut down
- Trickle charge -------------50mA
- Auto cut
Housing material: ABS
Packaging type: Clam shell blister
Packaging material: PET
Dimension (mm):103*65*27 Weight: 153g
2 LED indicate: Red on ----------Battery Charging Green on -------Charge 90%-100% complete Turn off ---------Stand by without battery in compartment Loose connections (replace battery); Polarity reversed (load the battery right side) Low voltage less than 0.2V Red flash (after 5min) -----Non rechargeable battery like alkaline, primary Bad battery Temperature >55 degree
Charge time:
|
Type of battery |
Charging Time (Hours) |
|
2 pcs of 800mAh Ni-MH AAA |
1.9 |
|
2 pcs of 900mAh Ni-MH AAA |
2.1 |
|
2 pcs of 1100mAh Ni-MH AAA |
2.6 |
|
2/4 pcs of 2000mAh Ni-MH AA |
4.8 |
|
2/4 pcs of 2200mAh Ni-MH AA |
5.3 |
|
2/4 pcs of 2500mAh Ni-MH AA |
5.9 |
|
2/4 pcs of 2700mAh Ni-MH AA |
6 |
This chart is for your reference only .The actually time may short than the chart
Instructions for use:
-Insert the rechargeable Ni-MH battery into the battery compartment -Make correct contact for polarity (+ and -) according to the sign in the battery compartment Connect the supplied AC barrel plug into jack on the back of the charger. Plug the AC plug into any available 100-240VAC outlet. -The Red LED will glow to indicate the proper charging. After the battery is fully charged, the red LED will turn off and green LED will light on indicating the charged battery is ready for use. -Unplug the charger and remove from the charger when not in use.
Power supply:
Protect the power supply cable against the risk of being trodden on, pinched or folded, particularly near the sockets and the connection with the device. Keep out of the reach of children or pet. To disconnect the power supply cable, pull on the plug and not on the cord. If the power supply cable is damaged, stop using the device immediately.
Tips: It is normal for batteries to warm up while charging. They will cool down after they are charged. Store batteries in a cool dry place at room temperature. Rechargeable batteries gradually lose power when store. If they are not used for more than one year, charge the battery complete. but cannot use ,the battery may damaged. Replace a new battery. Not charging all the way? 1. Gently rub battery ends with a clean pencil eraser or cloth to remove any residue 2.Loose connections between battery and charger, replace battery into the battery compartment, turn the battery until LED turn red. 3.Polarity reversed, load the battery into charger in right side until LED turn red.
Warning: To avoid personal injury and property damage from, but not limited to, the risk of electric shock or fire: Charge only rechargeable Ni-MH batteries. Charging any other types of batteries may cause them to leak, rupture or explode. Do not open battery, dispose of in fire, put in backwards ,mix with used or other battery types or short circuit-may ignite, explode, leak or get hot injury Use the charger only in dry locations. Keep away from rain, snow or excessive moisture. Do not operate the charger if damaged Do not disassemble, modify any part of the charger ,or attempt to use the chargers as power source Always unplug the charger from outlet before attempting maintenance or cleaning, This charger is not a toy and should not be used by children or infirm persons without adequate training or supervision.
Approve: adaptor: CE
Material: ABS ROHS
One year warranty:
This Soshine product is warranted only to the original purchaser upon presentation of proof of purchase, to be free from defects in materials and workmanship for one year from date of original purchase provided that no other repairs, alterations or modifications had been attempted by unauthorized personnel. Not applicable to damage caused by normal wear and tear or misuse. Repair or replacement of charger at Soshine option. For more information, please contact your nearest Soshine sales office.
We provide different countries plugs for choice

About PCB

Related Products:
AA*4 2700mAh Batteries |